If you have a Rangefinder series 2 caravan or a control panel connected to Odyssey link by Bluetooth, this article will explain how to reset and reconnect the two devices.
Locate the system:
- In a Rangefinder caravan, the Odyssey link box is located in the cupboard by the step.
- Locate the Odyssey Link box.
- On the left-hand side near the bottom there is a tiny button.
- Press down for a few seconds, and a green light will appear.
- Once the green light comes on, you only have 30 seconds to re-pair the devices.
- You'll need to note down the serial number on the white sticker. It’s the longest number and starts with 'A' followed by multiple digits.
Reconnect with your control panel
- Go to the home screen on your control panel
- Scroll your finger from the top of the screen to the bottom of the screen, and a drop-down box will appear
-
Hold down the Bluetooth button. This is the second button from the left.
-
The pairing screen will come up, then press pair a new device.
-
When you see the serial number (the last 5 digits from the serial number) on the white sticker, click on that to pair.
-
Then go back to the main menu, and everything should be going well.
If this doesn't work:
- Go back down to the cupboard from step 1 and turn off the black switch which is located near the Odyssey link system.
- Get a paperclip, and you will find a small hole on the top of the outside frame of the tablet (control panel).
- Put the paperclip down the hole, and you should feel it touch a button. This will shut the control panel down.
- Leave it shut down for a few minutes, then turn the black switch back on, and it should re-connect.
If all the above fails:
- Simply unplug the Odyssey link unit from the charger and reinsert the plug.
- Leave the plug out for a couple of minutes. This will allow the CANBUS connection to power down and re-calibrate.
- The cable you need to unplug is the flat black cable with 'telephone' style connectors.
Clearing the OdysseyLink memory to get the green flashback:
- Pushing the green connector to the left allows easier access to the button.
- Hold down for 10 seconds until it flashes red to clear any previous pairing.
- Try disconnecting and reconnecting the CANBUS cable before trying to pair.
- If the can is active, upon reset, it will flash blue-green, blue-green, and then go out until the pairing is active.
- The pairing mode is only active for 30 seconds, after that the light goes out.
- If the button is pressed twice quickly, it will turn on and then off the pairing mode without being seen.
Note:
The system has a five-pairing limit, which may require resetting the Odyssey link. This can be done by holding that same pairing button on the left side of the Odyssey link for 20-30 seconds. It will flicker, indicating that the memory has been cleared.
Click here to download the Odyssey Link Manual for more support.